Just bought a Z center lambo light panel from retro620ti does anyone know if they are for series 1 cos mine is a series 2 and the fookers dont fit :headvswal

should be the same????

Well the three pots either side do not go through the existing holes left by the original lights

You have to take a grinder to the body to get them to fit ;)

thats prob cos its just an aftermarket item. A bit/lot of DIY will be required i'm guessing

Well the three pots either side do not go through the existing holes left by the original lights

i think you need to do a little cutting on them lights mate regardless of s1 or s2

Seriously!!!!!?? Do i have to chop out to get em to get em in?

andyduff said get ya grinder out lol.

yep you certainly do, dont worry about it, it wont make any difference to the strength of the car

i think i'm changing my mind about chaining my rear lights to the quad conversion lol

I just bent the metal outta the way, that way i can reverse it :)

I just bent the metal outta the way, that way i can reverse it :)

 

good thinkin ;) i might trial fit mine this weekend if i can be bothered! that tar around standards is some sticky icky ickkkyyy!

I just bent the metal outta the way, that way i can reverse it :)

 

 

Same hear lol!!!

 

Singh my coop lights will be available soon as im changing them but im keeping the pannel ;)

Same hear lol!!!

 

Singh my coop lights will be available soon as im changing them but im keeping the pannel ;)

 

i have the panel and lights..

 

so i should end up lookinjg summat like this....

 

http://www.zcentre.co.uk/shop/images/fuji%20film%20Q1%20digital%20camra%20048.jpg

 

lol...

Oh right i thought you just had the panel lol!!!

Oh right i thought you just had the panel lol!!!

 

i got the outer ring LEDS from a member on here, and the centre lights from ebay. look smart, just not fitted lol. i'm slow with fitting... took long enough getting dump valves on lol