Hi

The Zeds use t25 turbos from what I can gather, these units spool up v fast but generate lots of heat, ( found this out on a 620ti as they use t25's ) can anyone tell me what the intake temps are after the I/C's , and can the T28 be fitted from the 200sx as this was a straight swap on the Ti.

Many thanks

Kev

Hi

The Zeds use t25 turbos from what I can gather, these units spool up v fast but generate lots of heat, ( found this out on a 620ti as they use t25's ) can anyone tell me what the intake temps are after the I/C's , and can the T28 be fitted from the 200sx as this was a straight swap on the Ti.

Many thanks

Kev

Quite a few lads have T28's fitted to their Z's

Wish I could afford the conversion, as you'll also need 555 injectors

hi, you can fit the t28's, lots of mods to do to fit, make sure you get good ones as the engine will have to come out. try smithy's if you want a full new kit. If you are planning on running high boost, then intercoolers will have to be uprated. lots of money involved.

Hi

The Zeds use t25 turbos from what I can gather, these units spool up v fast but generate lots of heat, ( found this out on a 620ti as they use t25's ) can anyone tell me what the intake temps are after the I/C's , and can the T28 be fitted from the 200sx as this was a straight swap on the Ti.

Many thanks

Kev

 

T28 is the size i dont think it will bolt straight on to from a 200 i would of thought the manifold fitment would differ,might be wrong though

 

someone will give you a deffiant answer

The T28 is the same bolt pattern as the t25 in the 620ti but the body needed rotating about 35 degrees to get it to fit on the rover , then all you had to do was fit a amended actuator and arm as the holding bracket was different.

this is where i sourced mine from and it was the top *****x

http://www.atpturbo.com/Merchant2/merchant.mvc?Screen=CTGY&Store_Code=tp&Category_Code=GRT

actually, Zeds use TB22 turbos which are slightly smaller then a T25 (especially the turbine side) also the turbine side bolt pattern is different (4 bolts instead of 5 bolts in a T25/T28)

 

-Eric

I've got 1 T28 fitted to mine :)