Hi,

car failed MOT today because we couldn't adjust the headlight beams, can u beleave that!!!

Have taken both headlights out ( now that a job and a half) and have ordered new cogs as the the ones in the adjusters have cracked, those of you who have been there before know what I'm talking about, but how do I free the cog thats in the unit it self, as its very stiff,

:headvswal

Help and advise greatly apprecited

Cheers

Tony

:bow:

Read through this see if it helps http://aus300zx.neuralmotion.com.au/tech/headlight_disassembly/headlight_disassembly.htm

cheers mate,

thats exactly what I needed to know,

with a smile on my face and knowing which direction to go I should be able to get this sorted now.

Thanks again

http://300zx.co.uk/forums/newreply.php?do=newreply&noquote=1&p=467824#

banana

Tony

http://300zx.co.uk/forums/newreply.php?do=newreply&noquote=1&p=467824#

Smilie

Had to do this on mine a few years ago - took ages !

Did mine a while back , used the Tamiya diff cogs , very worthwhile :dance: the only thing i would reccomend is to use a electric fan heater and warm the whole glass and use a wide bladed scraper to gently lift the glass away rather than a screw driver as shown , the glass can chip or crack very easily. You could always paint your bezels while there out, a bit of wheel silver and a coat of lacquer and they look the mutts :bow: :bow:

Just to give you an idea wot silver bezels look like. or you could colour code them to your motor :dance: HTH

Car past MOT today,

Just Like to say THANK YOU VERY MUCH :bow: