how do i reset ecu to get rid of error code?

dnt no how to do it on th ecu but u can disconnect th battery, step on th break peddle and leav it for half n hour

Either disconnect the battery or remove the error code via Conzult.

I think the ecu clears the old fault code after 50 starts as long as it doesnt come back again.

its easier than that,

when you short out the ign/chk pins on the consult plug and check the codes, short out the ign/chk for 2 secs again and the engine check light will stop flashing and stay on.

i found leaving the battery over night wasnt enough to clear the codes.

its easier than that,

when you short out the ign/chk pins on the consult plug and check the codes, short out the ign/chk for 2 secs again and the engine check light will stop flashing and stay on.

i found leaving the battery over night wasnt enough to clear the codes.

 

 

wat two pins are these?

sorry, the consult plug down beside the bonnet release, if you bend a paper clip and short out two of the pins for 2 secs with the ignition on, then the check light blinks the code,

there was a link but i cant find it.... any one?

found it!

 

http://www.twinturbo.net/ttnetfaq/FAQpages/ECUdiagnostics.html

cheers mate