got my TC working again :D

 

it was the abs channels that were screwed! it thought front was rear & left was right, apart from that it was fine ;)

 

iv loaded the zed.bin file now, is that the one your running?

 

changes i made for my car:

 

abs channels correct now

wheel diameters

upped the min rpm threshold to 1500

 

any other thoughts?

Enable plastic tyre mode :D

Originally posted by MikeGroves

Enable plastic tyre mode :D

 

tried that one, would you believe theres no such setting :D

See now if you had wired the ABS wheel sensors up correctly in the first place then you wouldn't have had that problem LMAO !!! ;)

 

Glad you got it sorted mate. I can't remember if you have launch or not but if you do then I would set that at about 2k rpm until you fit eagle F1's LOL.

 

In the wet setting are you getting any slip when you boot it in a straight line ?

Originally posted by SMW1

See now if you had wired the ABS wheel sensors up correctly in the first place then you wouldn't have had that problem LMAO !!! ;)

 

Glad you got it sorted mate. I can't remember if you have launch or not but if you do then I would set that at about 2k rpm until you fit eagle F1's LOL.

 

In the wet setting are you getting any slip when you boot it in a straight line ?

 

erm, there is no "correct" way to wire them up, thats why you have to configure them in the software :slap:

 

nope, dont have launch.

 

its a lot smoother now the cut tables are configured.

 

driving home, the only problem i could see was im getting misfire at low speeds when pulling away gently, i was gonna up the min speed threshold up to 15-20 kph