Wonder if anyone can help here... Just trying to fit the S2 seats I've bought from Ian this morning. Managed to get all of them in with no issues apart from the passenger side front.

 

My previous passenger seat wasn't electric however I knew there was a connector underneath so I presumed you could fit the electric passenger side, connect it and have no issues however, the wire connector is completely different.

 

Is there any way around this?

 

 

 

When my car went for spraying I was kindly lent a spare driver's seat. The seat connector was different so

I made up a small harness using male and female spade connectors. Not the prettiest but did the job.

I've fitted dual electric seats to mine and I cut off a length of the loom to fit my passenger one.

When my car went for spraying I was kindly lent a spare driver's seat. The seat connector was different so

I made up a small harness using male and female spade connectors. Not the prettiest but did the job.

 

Yes, my drivers one was different also but I easily swapped everything over for that.

 

- - - Updated - - -

 

I've fitted dual electric seats to mine and I cut off a length of the loom to fit my passenger one.

 

Any pics of what you did for the passenger side?

Yes, my drivers one was different also but I easily swapped everything over for that.

 

- - - Updated - - -

 

 

 

Any pics of what you did for the passenger side?

 

No sorry I just wired the passenger seat into the drivers harness since I didn't have the wiring in place.

No sorry I just wired the passenger seat into the drivers harness since I didn't have the wiring in place.

 

Thats not a bad idea actually. Juat need to get a connector from somewhere then

 

- - - Updated - - -

 

Anyone know what that connector is for under the passenger side seat??

Seat belt system.

Seat belt system.

 

So where does it plug in?

I just got a PAX connector for an S2 car and a long length of cable and spliced it into the driver's side harness. It's only 2 or 3 wires from memory. Just colour for colour.

I’m going to look at a breaker tomorrow to pull a few bits off. I can take a look under the passenger seat and see what connectors (if any) are fitted. If they look like what you need I’ll snip them off and send to you if it helps?

I’m going to look at a breaker tomorrow to pull a few bits off. I can take a look under the passenger seat and see what connectors (if any) are fitted. If they look like what you need I’ll snip them off and send to you if it helps?

 

That would be great, thanks! Think its 3 pins from memory :)

I just got a PAX connector for an S2 car and a long length of cable and spliced it into the driver's side harness. It's only 2 or 3 wires from memory. Just colour for colour.

 

Same as what I did above.

 

Full manual. Sorry mate.

[ATTACH=CONFIG]118724[/ATTACH]

 

Full manual. Sorry mate.

 

No worries, thanks anyway. Think I'm just going to get a new set of connectors and connect it from the drivers side