My 300 has always ticked over at about 950rpm so I'm looking at slowing it down a little ,is it in or out to slow it down ?

Also do I have to turn the car off then on again for it to re- adjust

You need to warm it up first then unplug the connection and set it to iirc 600rpm, upon replugging it will pop up to 750rpm. You should check the throttle position sensor, timing and for boost leaks first. Mine sits about 850/900rpm, but I know my base timing is wrong for idle as such due to the neutral switch buisness with the conversion.

Cheer's Steve I shall have a look I don't think i have any leaks but you never know

Unless you've checked recently I almost guarantee you will have a small leak somewhere.

Shit ,,so do I screw it in or out to lower it

I can't remember, you do it the engine running anyway so you will hear. You can turn it quite a bit before it goes mad.

Sounds a bit hit and miss to me ,I may leave well alone as its always been like this even after it had a spell at zedworld

Shit ,,so do I screw it in or out to lower it

 

In I believe.

It doesn't take much mind.

My 300 has always ticked over at about 950rpm so I'm looking at slowing it down a little ,is it in or out to slow it down ?

Also do I have to turn the car off then on again for it to re- adjust

 

Information herein:

 

https://z32.wikispaces.com/Idle+Control

Perfect cheer's Andy

All went very well, tick's over perfect no leaks and I didn't even drop the clip on the plug

cheers Andy and Steve