The fear is real.

 

Working on my Z project, pumping in a fair bit of £ to the rear, but now onto the front of the car.

 

It needs welded, I know a good guy, but would be easier for everyone with pre-fabricated panels for the sills.

 

I've seen all the posts for rear panels, but are there any available for the front?

 

Pictures of a hole in the side of the drivers floor pan after prodding with a screwdriver, and the side skirt which is a write off too.

 

The paint is my own doing. And don't worry, the jacks aren't under the sills, got two at the cross member, and two at the chassis

 

Cheers!

 

 

This may be of help..

 

http://www.mig-welding.co.uk/forum/threads/thanks-everyone.15465/

I've seen all the posts for rear panels, but are there any available for the front?

Full length sills are available from any Nissan dealer.

Thanks again redwine.

 

Hmm they are available.. but £259.10 + VAT + shipping for one outer sill haha, thanks though

Hmm they are available.. but £259.10 + VAT + shipping for one outer sill haha, thanks though

 

 

http://www.zcentre.co.uk/index.php?page=shop.product_details&category_id=84&flypage=flypage.pbv.tpl&product_id=613&option=com_virtuemart&Itemid=7

 

£195 + vat/shipping .

Mike at MJP might be able to shave a few quid off that.

Im doing the rear arches at the moment matey, I have done the sills a few years ago, my advice is if your going to do it, do it right the first time, cut out as much

rust as you can, and extend the targa roof drain hose that runs out of the sill just behind the b pillar.

Cheers for the advice all. After I've done the engine work I'll get it in for it's welding/potential MOT, if all goes well I'll get some nice pics too