am in the middle of a auto to manual swap what is the correct torque setting for flywheel and pressure plate ? thanks

http://www.300zx.co.uk/tech/manual/manual/cl/015.gif

thanks the link has the cover plate tq but not the flywheels tq do you have a link for that please

http://www.300zx.co.uk/cgi-bin/manual.cgi

 

I dunno wether you have used this before, all the bolt torques for the whole car are included aswel as exploded parts seriously usefull.

never seen that before just looked at it cant find the tq

There is a picture if a spanner round a nut at the end of the line with the torque numbers in NM, KG-m and ft-lb

thanks the link has the cover plate tq but not the flywheels tq do you have a link for that please

 

Here you go:

 

http://www.300zx.co.uk/tech/manual/manual/em/049.gif

83 to 93 then for fly wheel thanks

83 to 93 then for fly wheel thanks

 

Yes in N-m

 

so fly wheel would be 68 foot pounds and 30 foot pound for the pressure plate is that correct

Edited September 6, 201411 yr by dan300zx

so fly wheel would be 68 foot pounds and 30 foot pound for the pressure plate is that correct

 

Nissan give the range of 61-69 ft-lbs for flywheel and 25-33 ft-lbs for clutch cover. I normally just take

the mid point between the two figures - 65 and 29 in this case.

thanks for that