Hi. Purchased some metal door lock mechs to replace the broken brittle plastic ones. Fitted them fine but now can't get the door Handel to close fully. Been at this hours now. And even tried copying the other door but now that's gone the same. Seems to be something to do with the big metal arm which attaches itself to the Handel.

Have you put the passenger side one on the drivers side?

I did mine the day you mentioned it and using the exactly the same metal part with no issues.

As above, pretty sure they're handed.

They are definitely handed. If you hold up the broken piece that you took off against the new ones then you'll see which is the correct one.

Sorted it! Thanks buddy! Another thing .just went to top up the cars rad water and assuming the filler is on the the right side.... Pulled the stick and it was totally dry. Never checked this beforr and the card never once overheated. So I put some water in and after a while it's just coming out from underneath the car?? Is there some kinda overflow? I checked the rad cap and saw no signs of water either

Your supposed to top up by the rad cap as where your topping up on the front right is the overflow bottle.

Lol. Ok

Ahh. Ok. So do i fill via rad cap until it gets to the top?

I believe so mate, think you may need to run it with the cap off for a bit to get the air out though and top up accordingly.

You can run without a coolant bottle but I have just re fit mine and I keep it about middle on the dipstick.

 

Always fill by the rad cap, keep it full.