Hi guys i have a question about the PTU,so i tested the connector which goes into the PTU(seven pin connector)and i got 11.8 volts on six of them but on one end one i get nothing?I am guessing it should be 11.8 volts also.Should it?Also guys what voltage should i be getting out of the PTU,and how can i test it.Cheers guys

Power is transferred through it, think of it like a splitter block. So if you unplug the side that's feeding it you won't fervent voltage, you've in plugged it.

You measure as a power diode, put your meter on diode check one way measure about 950 ohms swap the leads you should not get anything.

this is measuring on the ptu only.

You measure as a power diode, put your meter on diode check one way measure about 950 ohms swap the leads you should not get anything.

this is measuring on the ptu only.

 

Yes i did that mate and i got 1.4 ohms and none by swaping the leds over

Sounds ok im not sure if there is a bridge rectifier in there im not sure, maybe other members have split one down?