Pistons and rods installed. Just waiting on a set of STDX King rod bearings to make some adjustments to my big end bearing clearances…. Unsurprisingly, the STD size bearings EPR used produced 0.0017” clearance not the 0.0035” quoted in the build sheet. Targetting 0.0025” for this build. Also reinstalled the @brettdempseyengineering oil tree. Oh and I will never use a ratchet piston ring compressor ever again, these ring compression sleeves are SOOOOO much easier to use!!
By
nickz32 ·
Hello hello everyone,
I have been a registered lurker for a few months now since i finally plucked up the courage to look for a Zed to buy.
Live in Surrey and currently drive a ............ 206CC:scared:
Getting rid or palming off to the GF to be exact so i'm now looking for my 1st Zed.
Always wanted 1 since i drove a 100NX years ago and thought **** it i'ma have 1, it's now or never.
If i seem stupid please be nice haha