have just had my bumper repaired and resprayed and as a result the sticky number plate has been removed and i need to put a new number plate on. where should i mount a normal plate?

I would pop it on the front where it should be and not on the nose :)

if ya gonna mount it, i would suggest you do it out of site as it could be seen as being a bit of a perv

you could have a bracket made up and mount it similar to where mine is

A nice 3/4 size one where the white box is :)

 

Stick it on "L" brackets in the big grille hole slightly leaning back into the hole either top or bottom. That will be legal and wont interupt any air flow :D

my letters were 7mm to short and i got nicked £30.

http://i218.photobucket.com/albums/cc184/svodiac/dragon433.jpg[/img]"]

A nice 3/4 size one where the white box is :)

 

 

Thats what I would do

my letters were 7mm to short and i got nicked £30.

http://i218.photobucket.com/albums/cc184/svodiac/dragon433.jpg[/img]"]

 

nice zed nap:bow:

thanks mate.

might go for stick on plate.

A nice 3/4 size one where the white box is :)

 

 

I got a £30 fine for that :mac1:

Then I screwed mine to the front grill (similar to yours) and it acted as a wind break for the radiator, so now I have a full size one stuck right on the nose :rolleyes:

i know its not the same bumper but iv got 3/4 sized one too where yours is being recommended.

 

Best place for it really

thanks mate.

might go for stick on plate.

 

:slap:

 

stick on plates on very uncool. unless you have an etype or something. If you have to have full size letters then trim the plate down and lose some of that white from the edges. It pisses Si off. :x:

:slap:

 

stick on plates on very uncool. unless you have an etype or something. If you have to have full size letters then trim the plate down and lose some of that white from the edges. It pisses Si off. :x:

 

thats just what i have done.

import letters are smaller so now i have a motterbike size number plate.they wont get me this time.

http://i218.photobucket.com/albums/cc184/svodiac/P5310108.jpg[/img]"]http://

thats just what i have done.

import letters are smaller so now i have a motterbike size number plate.they wont get me this time.

http://i218.photobucket.com/albums/cc184/svodiac/P5310108.jpg[/img]"]http://

 

I would swap that for a 3/4 size plate, your blocking a fair amount of air to the rad there.

3/4 size FTW :duffer:

 

Looks great and blocks no air to important bits :nana2:

your prob wright but had no prob,s yet.

there is a lot of room for air flow on the front bumper.the plate does look a lot bigger on photo but take it from me its half the size of the jap plate that was on the car.but i have seen a few with the stick on plate and dont think they look that bad.

just looking into how leagal they are.dont want to end up trying to peal it off the paint work.if there is nowere to mount the plate then i have been told it is fine to use a stick on plate.

A nice 3/4 size one where the white box is :)

 

missed this post sorry i agree with Isaac & Legrath though ;)