would these fit a standard zed?

9.5" and 8.5" width by 17"

 

The are Front 45et Rear 42.5et.

 

set of alloys on ebay from a mazda rx7.

think the offset would be too far inside the arches unless you were using spacers. Think the stud pattern is the same they are a good width too

Edited May 17, 200916 yr by 8ace

Yeah you will need spacers for them to look good. You need around 10-15mm hubcentric spacers :)

thanks guys..!

If you are shopping for Z wheels the PCD is 5 x 114.3 - this is a common size for larger jap cars - i.e. 300zx, Mitsi GTO, RX7, Soarer, Supra, 350Z, Evo 8 etc. :)

They'll fit fine. You'll need some decent hubcentric spacers though for them to sit correctly and look good. 25cm ones for the front and about 5 for the rear.

 

17" generally look too small IMO.