Can you just swop velour manual seats in a series 2 for electric leather seats from a series 1? i.e will it fit the loom ok or will I need to modify?

I have a series 2 passenger seat which I retro-fitted a bit of series 1 loom in the car. Works fine.

 

But, by the looks of it, you're wanting to fit a series 1 passenger seat which isn't electric. Only way to convert, would be to pull all the squabs and material off and swap them over.

 

But, by the looks of it, you're wanting to fit a series 1 passenger seat which isn't electric. Only way to convert, would be to pull all the squabs and material off and swap them over.

 

It's the other way round mate, I want to put an electric series 1 in to a series two that has manual seats.

Oh right. Need to check if the wiring is even there.

I'll have too get it out and have a look. Was there any difference to the looms between S1 and S2 electric seats?

Hi mate from what I remember the S2 seats and S1 seat connectors should be the same. The only differences are when you get heated seats which have a 6 pin plug or if you have the seast belt tensioners also wired from the plug. These are all pretty easy to solve though.

Hi mate from what I remember the S2 seats and S1 seat connectors should be the same. The only differences are when you get heated seats which have a 6 pin plug or if you have the seast belt tensioners also wired from the plug. These are all pretty easy to solve though.

 

Cheers for that mate, but I had a look and all i've got is the seat tensioner wires :( So I'm going to have to make up some leads for connecting my electric seats, which should be fun... not