General Discussions - 300ZX Related

After new alloys now but have just realised I don't seem to have the 'key' or whatever I need to take my wheels off. Any idea of there is a space in the zed that this is usually kept in?

Your PM inbox is full. ^__^

As blokes why do we all refer to zeds as 'her', do the ladies on the site call theres 'him'???? if so, what are the names we call our zeds, cant print the names i call mine but thats only when im trying to get the dam engine out so i can get HER running again, i think i will call her PAMMY, as she looks greatif she is topless or not and has loads fo plastic. Anyone else have a name for their zed?????????

What do you think of this? Someone here installed it?

right as you all might know ive had a problem with my zed since i brought it and now its getting me down, problems are cuts out at idle, poor performance, erractic gear changes etc etc, all the faults was aiming at TPS, so for £50 i put a new on one and set it up etc but to no joy and no ECU fault codes, now im confused. yesterday after hours of searching forums i came across an artical about blink testing my auto box just done the test and its came back throttle sensor circuit!!!!!!!!!!!!!! please help regards andy

Is it just me or are the zeds radiators seem a little small??

it was on the ring road bout 7.30 this morning think it had a 99spec spoiler

:hyper: saw you near luton, i was on the other side in a white mondeo so you might not have seen me. First one ive seen on the road!

Evening All. After some wan*er decided to kick/stamp on my front bumper and cracking basically most of the bottom half completly off :rant: , I am now in need of a passenger side Intercooler duct. But seen as i will be replacing one, I may as well replace the pair while the front bumper is off. So my question is does anyone know where i can get a pair of Stock IC ducts from? If their is such a place. ;) Regards Rob

Right before anyone says Heater matrix I assure you its new and not that as car doesn't use water. I have brand new OEM door seals, complete new OEM Targa seals and Targa Door seals. It only happen when car is stood not when car is moving. Where do the Targa Drains go? could one be damaged and leaking into foot well.

Who's seen the ZED in the new orange ad?? I saw it on sat.

hello guys wondering if any of you have a series 1 ptu to test this ****in fault on my car. its doin my head in now. everytime she gets hot she cuts out. leave for abit then it starts up and then cuts out again down the road. please please somebody give me a ring as i,m not regestered. or leave your number and i,ll send the cash in the post. my number is 0191 5208937 or 07737037616. email is . dgsignmakers@aol.com thanks george

hi guys and gals,ordered some dip beam bulbs off ebay,bet u no whats comin next!!!!!!!!!!!,i got H1,S :slap: ,and guess who didnt check if they were 4 a jap spec MEEEEEEEEEEEEEEEEEEEEEEE :slap: ,only cost me £7 so not so GUTTED till i went to my local toy shop,and after some ringing around they found mine need H3c,only £17.50 EACH :mac1: ,so now hav a set of useless bulbs 4 a uk spec,so does anyone no of anywhere cheaper,only one bulb workin at mo so look a right TWAT drivin at night,plus cant see SHITE cause its my drivers side blown and im as blind as a bat even with my glasses on,many thanks in advance PEEPS

Members, You will recieve your 2007 Calendars through the post in the next 2-3 days (providing you have already forwarded your address and paid) If you haven't done the above, can I ask you again, to do so ASAP. Can you please use this thread to confirm that you have recieved it and also to give the club some feedback on the quality, content or the design of the calendars, whether it be good, bad or indifferent. Please do not use this thread for anything else, other than confirmation of delivery and feedback Thanks Steve-300ZX Membership Secretary

Whats the diffrance between a tt and a na fly wheel?

guys :cool: just had the zed back after a full engine rebuild and the tubs i used were turbo technics stage 1 these have adjustable wastegates and are set at 14psi from the manufactures, they also have staggered seals as i have decatted also, question is :smash: am i ok to run at 14psi with the stock ecu?? it is socketed to take a remapped ecu if i need, my mods are se-nissan twin induction kit, decatted, stainless exhaust, stage 1 tubs, stock internals. any help much appreceated.

Ok so how long till the 1st "mod"

Lets find out.

Can someone explain to me the logic behind the idle speed?... (N/A Jap '92) On cold mornings before the engine warms up there seems to be different idle speeds... circa 2000rpm, then down to something around 1500rpm, eventually settling out around 900rpm once warm... On warm days, or on returning to a still warm engine, the idle speed is around 900rpm... Anyone of the resident experts care to explain whats supposed to be happening?? :) Thanks in advance Dave

red zed turning left on roundabout heading towards a34 between 8 and 8.30 am

Pretty sure it was a TT, had BBS type rims on it, turned into the Civic Centre at about 8pm last night.

Completely stock, was travelling toward Cheddar today.

Can anyone help me with my z32 auto 1990 import as there is a very loud banging cumming from under the centre consol i think its cumming from ether the gearbox or the exhaust i have done i search but no one has described as being the same prob as mine as the banging does not go away after the car heats up its constenly there any help would be great thanx

Will these rims fit? ADVAN RG WHEELS Size:17x7.5 Bolt Pattern:5x100 Offset:+48 ? Thanks in advance ;)

is there any advantage of fitting skyline brembo r33 rear calipers?? would they fit?? just like the look of them!!! :cool: