General Discussions - 300ZX Related
Z related topics and discussions
79,698 topics in this forum
-
Have bought a new genuine HKS mushroom element .I ordered a new one and its got 3 layers, foam rubber and foam it says dry on the pack im sure my old one isnt like this . i wonder if they have changed the design to keep water out of the air flow meter.
-
- 0 replies
- 262 views
-
-
Anyone have the part number for the expansion tank near rad and pipework to Rad Plus pipe to water fill area (are they all one unit?) Broke mine in recent tip Time to repair Thanks Roy
-
- 3 replies
- 424 views
-
-
Anyone know of somebody good in the Grimsby/Lincolnshire/Humberside area that can do me a complete respray. After some w****r bumped the front end last week, I've decided to get the whole car done. Any ideas anybody?. Harty.
-
- 5 replies
- 594 views
-
-
hey i saw a white zed with blacked out rear light panel going down edgeware road now, anyone fro here? darren
-
- 0 replies
- 292 views
-
-
Hello all, I get this relay sound and the interior light flickers on and off when I do over a certain speed I think its the boot lid switch? just had a look for it and I cant see it anywhere? can anyone help? cheers!! ;)
-
- 3 replies
- 330 views
-
-
Do the windows steam up at this time of year on all zeds (ooh ahh madam)!!! No seriously tho, is it coz of the weather, or is there a problem with my car? Quite often the windows mist over and I have to put air con on, that clears it quickly. Then when I turn air con off they steam up again pretty quick, is this normal, or do you think it could be that something (coolant) is leaking somewhere? This doesn't seem to always happen, but quite often. Also, I seem to think that I can smell coolant or something, but no one else seems to be able to, so don't know if it's just my imagination!!
-
- 19 replies
- 1.4k views
-
-
Simple question - best to fit 3 point & make new rear mountings or 4 point and use existing lap-belt mounts? I was going to go with a 3 point, but a 4 point will be easier if the existing mounts are suitable (suitable as in is the angle of the innermost any good for harness). Oh, and i'm not putting the rear seats back in! Cheers Rich
-
- 4 replies
- 456 views
-
-
-
i have just got a set of Rays 350z 18" wheels (8" front 8.5" rear) and I need to get tyres 225/40/18 and 245/40/18 tyres (i think) I have not yet tried Bridgestone RE050A tyres, has anyone had experiance with these? has anyone compares them to Falken 452s? Also what is the difference between these two tyres: bridgestone re050a 92y and bridgestone re050a 88y thanks darren
-
- 3 replies
- 420 views
-
-
http://www.youtube.com/watch?v=AcX-dGFArOk :)
-
- 2 replies
- 455 views
-
-
Can we have a best zed competition for xmas voted for by the members? We could have different categories, best body, best tech, best overall etc. I know we do mini versions of this at some of the National meets, but I don't remember doing a big version of this voted for by everyone. What do you guys think?
-
- 22 replies
- 1.3k views
-
-
Does anyone know of a specialist near to Guildford in Surrey that can do a full 60K service? Cheers
-
Hi , I have two questions for you guys, first one is a braking one: When I brake hard I'm getting a squeeling noise, now this isn't a squeel coming from the pads, it's coming from inside the car, like from the brake pedal itself, also I'm getting real spoungey feel to the pedal too. The second is I'm getting a knocking / rattling noise coming from the front drivers wheel area, it knocks and rattles when going over ripples in the road, or over small manholes and strangely when coming down a speed ramp but not up a speed ramp which is odd, this happens whether turning or going straight, I changed the anti roll bar endlinks thinking it might be them, but no. …
-
- 7 replies
- 621 views
-
-
-
Has anyone tried the front or back strut braces that crop up on Ebay? I know the front can be (very)awkward, but the back one must be fairly straightforward surely? They're on Ebay for £20! Cheers, Tony
-
- 6 replies
- 582 views
-
-
What tyres are best to get for a Z, Ive bought a 93 reg N/A manual import. Pick it up in a bit over a week. Just i heard jap tyres are crap, wondered whats best and how much i can expect to pay ?
-
- 13 replies
- 612 views
-
-
Gonna get my zeds ecu mapped just have a few questions which is the best chip to buy? what fuel do i have to run the car on do i need a diff exhaust to gain real benefits? any advice would be welcome thanx all
-
- 4 replies
- 348 views
-
-
Does anyone know where there is a rolling road in the Tyne & Wear (Gateshead) area that will test a 300zx? I have contacted a couple and I am informed that most Z's are too low for their's and as mine has been dropped (about 3" at front). Should I give up on the fact of using one? Obviously I would love to test the power of my newly aquired Z (89 TT auto) so I can watch it's progression over the forthcoming months as it upgraded but also because someone has knacked my speedo and it's needs calibrating (I am no good with electrics).
-
- 0 replies
- 271 views
-
-
i'm having trouble tracking down an answer to this: Smithy's 6mm silicon vac hose will hold up to temps for a water bypass? Or should I get some 3-ply? Thanks ;)
-
- 6 replies
- 715 views
-
-
I'm thinking of treating myself this christmas to a remote starter, as it's getting cold now, plus i'm getting lazy. I looked on ebay an saw one there which looked pretty good. But there was a not that said it was not for an automatic. I've asked the seller if this was a feature that was not for an automatic or if it was the whole set up that would not work for my car. He did reply an say that he was not 100% sure but would gladly find out for me. Does anyone know if there would be a reason that a remote car starter would not work on an automatic? :confused:
-
- 16 replies
- 963 views
-
-
Does anyone know what the DEPTH size is for front speakers :confused:
-
- 5 replies
- 439 views
-
-
http://guides.finalgear.com/files/Top_Gear_Classic_Episodes.htm 1992x06 00:00 Intro 00:33 Group Test (Jeremy Clarkson) 10mins: - Porsche 968 - Jaguar XJR-S - Nissan 300ZX ARRRGGGHHHH can't find it anywhere, the torrents are dead on all the sites If i can get hold of it from someone i could capture it and stick it on you tube
-
- 26 replies
- 1.7k views
-
-
hi all, seen some breakers in the forsale section, but was woundering is it worth getting it reconned or risk a working second hand unit? any good ones available anywhere? thanks mike :)
-
- 7 replies
- 526 views
-
-
put in you weigth of your car bhp and it will tell you 0 to 60 1/4 mile ect. but take it with a pinch of salt! http://www.letstorquebhp.com/calculator.asp but wot is the weight of a standerd 300zx tt ??
-
- 3 replies
- 395 views
-
-
Can anyone suggest the best way of putting on a wings west rear skirt please, IE the best stuff to use for the job, many thanks in advance.
-
- 6 replies
- 539 views
-