Steams

take them off then...... :lol:

I'd probably just be escorted off the premises by a Constable mate..!! :lol:

oh yeah, great sport and sexy women, what more do you need....:clap:

:lol: of course it will mate. Probably start with the wipers not wanting to come off. lol

Could have been this lot ;)

aaw, I missed that bit :(...:lol:

where's mine!!! :laugh:

If you have conzult it can put the HICAS into diagnostic mode. Haven't used it myself as I've ditched it. HTH

Can't tell you which plug it is exactly but it's a two pin connector at the back of the engine and the only loom part that goes down the back of the engine. The EGR valve may will be in the way (assuming you've still got one). Find the lead that is going into the middle of the engine at the back and follow it up to the connector. This will be the DET sensor cable as the sensor is bolted to the block in the valley between the cylinder heads. Sorry I can't be of more help.

That's shocking mate! I blame the parents.......:laugh:

Welcome to the club mate and thanks for your support :thumbup1:

looking much better matey :)

Don't know how much they're worth matey but a good set of knives can cost a fortune.. And that looks like a good set of knives :)

It's fairly easy mate, been a little while since I did mine but basically it's wipers off then undo all the little plastic screws. You'll need to lift the bonnet for some and lower for others. The main problem you'll probably get is screws just turning but not coming out. Use a flat blade screwdriver to gently lift the screw while turning it and they'll come out. Halfords do plastic screws for the round ones but don't lose the rectangular ones as they are harder to replace. HTH

He can't answer you, Tim has throw him into the abyss :lol:

Think they're going to need to use an electric cattle prod to get him off.. - - - Updated - - - He's being saved for the rainy days :laugh:

might be being picky here mate but they don't actually represent any country. lol

:lol:

Told ya mate, saved the best till last :thumbup1:

Gutted for you mate :( Has it caused a bigger problem near the front strut towers?

:thumbup::laugh:

no a spanner.....

I used a bolt and put a rusty nut on the end of mine, little tip for you there :lol:

did you sneeze there mate ?

That's what he's been told mate. He's had it from new and it's done 80,000 so it's done well really.