Jump to content
View in the app

A better way to browse. Learn more.
300ZX Owners Club

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Bulkead routing...

...I know this has been covered, but I'm trying to work out which bungs I need to remove in order to run a powercable up to the battery. Now, take off the lower part of the arch liner and there's a grey bung at the bottom. I popped this off and sure enough, it does go someway into the bulkhead...but to where?

 

I took up the carpet and took off the ECU kick plate, shone a torch through from the outside to see if I could see where it went....darkeness.

 

Am I going in through the right place? Or is there another bung elsewhere?

 

Cheers

  • Quote

    • Featured Replies

    not too sure about drivers side si, but i run my amp cable through a bung behind the passenger side repeater. just remove the inner wheel arch liner and its a little lower than the side repeater, you will see where the wires go through. not sure if thats any help to you.

     

    in fact, im sure you are in exactly the right place where you are now. i just put a slit in the bung after pulling it out, then pushed the cable through. it came out right in the left corner under the ecu cover.

  • Quote
    not too sure about drivers side si, but i run my amp cable through a bung behind the passenger side repeater. just remove the inner wheel arch liner and its a little lower than the side repeater, you will see where the wires go through. not sure if thats any help to you.

     

    Thats where I routed all my boost controller cables/pipe work ;)

  • Quote
    • Author
    not too sure about drivers side si, but i run my amp cable through a bung behind the passenger side repeater. just remove the inner wheel arch liner and its a little lower than the side repeater, you will see where the wires go through. not sure if thats any help to you.

     

    in fact, im sure you are in exactly the right place where you are now. i just put a slit in the bung after pulling it out, then pushed the cable through. it came out right in the left corner under the ecu cover.

     

    The bung I saw was the one right at the bottom. Not the same one as the repeater is half way up the wing?

  • Quote

    it was a while since i put the cable through, its lower than the repeater but its about inline with the repeater from a vertical point of view. from what i remember it already had wires going through the bung.

  • Quote
    • Author

    Sounds like I need to completely remove the arch liner then to get at it.

  • Quote

    • Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.

    Guest
    Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
    Reply to this topic...
    https://www.300zx-owners.club/forums/topic/92730-bulkead-routing/
    Go to topic listing

    Recently Browsing 0

    • No registered users viewing this page.

    Important Information

    Terms of Use

    I accept

    Configure browser push notifications
    Chrome (Android)
    1. Tap the lock icon next to the address bar.
    2. Tap Permissions → Notifications.
    3. Adjust your preference.
    Chrome (Desktop)
    1. Click the padlock icon in the address bar.
    2. Select Site settings.
    3. Find Notifications and adjust your preference.