Wanting to change wing side repeaters and front bumper indicators. I can do the front bumper ones they are easy I've had those off already to remove some condesation in the ones I have and seal them up. Never took the wing repeaters off though are they easy to do? Mine are all faded orange and look a bit rubbish :cool:

Wanting to change wing side repeaters and front bumper indicators. I can do the front bumper ones they are easy I've had those off already to remove some condesation in the ones I have and seal them up. Never took the wing repeaters off though are they easy to do? Mine are all faded orange and look a bit rubbish :cool:

 

Quick question - how did you seal up the lights? As in what did you use? A few of mine have quite bad condensation so would be a job worth doing for me I think...

The side repeaters have rubber everywhere so should be ok if not the old clear silicone will come out. The front indicators are the jdm one don't think i'll bother with crystal as not too sure if i will like them on there. Mine also have condensation in them I had the hairdrier on them then resealed them with clear silicone around the edges you can't see but still getting in somewhere

Crystal fronts look far better. Cover the other holes with foil and they wont notice.

 

Make sure you use chrome bulbs on sides and fronts and you'll lose the fried egg look!

 

Regards

 

Dave

Looking very good, just need some silver bulbs now :cool:

 

are these silver chrome bulby things ok through MOT's I gonna get some me thinks also are the fronts 382: 180 DEGREES PINS (OPPOSITE PINS) or 581: 120 DEGREES PINS (OFFSET PINS)

 

cheers

No probs cos they still flash amber!

 

Regards

 

Dave