Mines ecu

Followers

October 21, 200718 yr

Just got hold of a mines Auto ecu for a future upgrade. is sealed with gold plate and tags mines japan. I have cat backs an an apexi. next to fit oil cooler & PCV's in december for later power upgrades (boost control). Can I put this mines ecu in now at standard boost So i can get used to driving it? I understand I will get no more power fron it also what fuel to use JDM Auto with this ecu optimax current. Cheers

Quote

October 21, 200718 yr

Just got hold of a mines Auto ecu for a future upgrade. is sealed with gold plate and tags mines japan. I have cat backs an an apexi. next to fit oil cooler & PCV's in december for later power upgrades (boost control). Can I put this mines ecu in now at standard boost So i can get used to driving it? I understand I will get no more power fron it also what fuel to use JDM Auto with this ecu optimax current. Cheers

yes and yes ;)

Quote

October 21, 200718 yr

mines got one on... (No pun intended) and its fine.. Infact i didnt even know it had it until i came to pull the ecu out to send it away to be chipped... Bless my car, its full of suprises!

Quote

October 21, 200718 yr

Author

mines got one on... (No pun intended) and its fine.. Infact i didnt even know it had it until i came to pull the ecu out to send it away to be chipped... Bless my car, its full of suprises!

I hope mine aint already done yet grr I assumed not as everything sept zorst was stock when I bought. Cheers all

Quote

October 21, 200718 yr

Author

Also Ehat boost will this ECU run?? I plan to fit new boost gauge and 1mm mig tips would this be ok or safer with 1.2mm

thanks in advance

Quote

October 21, 200718 yr

Author

Just got hold of a mines Auto ecu for a future upgrade. is sealed with gold plate and tags mines japan. I have cat backs an an apexi. next to fit oil cooler & PCV's in december for later power upgrades (boost control). Can I put this mines ecu in now at standard boost So i can get used to driving it? I understand I will get no more power fron it also what fuel to use JDM Auto with this ecu optimax current. Cheers

sorry is vpower not optimax I use. (if this is better or worse than optimax)What boost can this ecu run safely with correct cooling etc.Any users of this ecu

Quote

October 21, 200718 yr

sorry is vpower not optimax I use. (if this is better or worse than optimax)What boost can this ecu run safely with correct cooling etc.Any users of this ecu

Vpower is same as optimax just rebranded

Quote

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.

Reply to this topic...

Followers

Go to topic listing

No registered users viewing this page.

No registered users viewing this page.

Simply Japanese at Beaulieu 19th July 2026

I was just completing my booking but realised that it’s one of my daughter’s 16th birthday! I’ll check what she’s up to and see if I can get a pass! She may come with me, but doubtful. Will update as soon as I know.
Steve 😁

By cybernet · 9 hours ago9 hr
Check engine light comes on and off sporadic.

Those codes are all pointing at a related issue. A/F ratio falling out of range, heater elements within the O2's out of temp range, EGR sensor or exhaust gas temp falling out of range, etc. There is a few areas to consider...
Was any work recently done to the car that may have triggered this? When was the last time you replaced the O2 sensors? Check the O2 connectors and wiring to make sure one of them hasn't contacted the exhaust or melted. Any exhaust leaks especially before the cats? When was the last time you performed an induction service and cleaned the intake, TBs, IAC, etc? The EGR and IACV love to get carbon buildup over the years and can affect flow, similarly can happen to the vac lines to the factory wastegate control solenoid. You mentioned the car felt like it was still running well, so no idle RPM fumbling, hanging, stumbling, etc? Are you running an aftermarket boost control solenoid or OEM? Sorry for the load of questions, but need a bit more to go off of to help point you in the right direction.
Even though the vehicle has considerable low mileage, it's still 30 years old. If it's kept in a garage it tends to handle the elements better than sitting out in the external environmental conditions and will need more routine maintenance and care regardless if it's being driven or not. (i.e. 60K / 120k maint w/ timing belt)

By protoj · Tuesday at 18:481 day
JaiKai - MK2 - Ziggy Build

Time to clean the AC parts as i found a birds nest in it.

By JaiKai · Tuesday at 12:041 day
Check engine light comes on and off sporadic.

Hello, I have a 1996 twin turbo manual with 64k miles. I recently started having the check engine light come on sometimes and other times it doesn't. When I checked the codes these are what I got : If anyone has had these same codes what did they change to fix the problem. Car runs fine with check engine light on but want to fix issue. Any help would be greatly appreciated. Thank you.
P0400
P0136
P1150
P1155

By JB300ZXTT · Monday at 22:142 days
UK Importers Advice

Thanks for the recommendations, few different places recommended Gorilla so I will get in touch with them.

By CarmageddonTheMusical · Sunday at 13:333 days

Sign In

Mines ecu

Featured Replies

Join the conversation

Recently Browsing 0

Recently Browsing 0

Popular Posts

Simply Japanese at Beaulieu 19th July 2026

Check engine light comes on and off sporadic.

JaiKai - MK2 - Ziggy Build

Check engine light comes on and off sporadic.

UK Importers Advice

Important Information

Account

Navigation

Search

Configure browser push notifications

Chrome (Android)

Chrome (Desktop)

Safari (iOS 16.4+)

Safari (macOS)

Edge (Android)

Edge (Desktop)

Firefox (Android)

Firefox (Desktop)