I have just got hold of a copy of Desktop Dyno 2000.

 

So for my first 'project' I would like to do a simulation for Z32 TT engine.

 

Does anyone here have exact specifications for our engine? I need all obvious stuff, bore, stroke, etc. I also need more in depth info like cam timing, valve sizes, turbo type (std) boost pressure etc etc.

 

Any more info I have left off please let me know, too much is never enough :D

 

If anyone knows where (on the 'net) I can go and find such data, then also let me know :)

 

Many thanks in advance,

 

Robert.

Heres the basic info:

 

VG30DETT:

2960cc 6 cylinder 60deg V

Bore 87mm Stroke 83mm

Compression 8.5 to 1

Two Garrett T2/2.5

Power 280bhp at 6400rpm (UK) 300bhp at 6400rpm (US)

Torque 274lb ft at 3600rpm (UK) 283lb ft at 3600rpm (US)

Rev limter 7200rpm (std)

 

Not sure about the rest though.

 

 

------------------

 

Trev

1990 300ZX TT 2+2(import)

http://www.300zx.co.uk/rides/trey/

Most info can be found in the manual.

 

Think is starts round about this page http://www.300zx.co.uk/cgi-bin/manual.cgi?list=em&dir=&config=&refresh=&slide=62&cycle=off&scale=0&design=default&total=69

 

Move forward through the pages.

 

Stuart

.

 

[This message has been edited by dunk300zxtt (edited 10-06-2002).]

Cool, thanks guys.

 

I'm still short of a few bits of data though.

 

I need induction airflow.

 

Also full turbo specs.

 

I.E. Airflow; intercooler efficency; pressure ratio (wtf?); boost limit (7psi??); surge flow; turbo efficency.

 

Also need valve lift length.

 

Cheers guys!!!

 

 

Robert.

 

------------------

 

I only use the brakes so I can accelerate all over again.