Hi peeps, need some help in wiring up my new greddy boost guage ( electrical ) as my oem guage is dead as dosen't do very much !!! ...also got a temp ( water - electrical ) guage while i was at it and just need info again in how to wire it up and connect. All i have at the moment is what Chris ( greddy) had sent me and if there is anything else I need any help would all be appreciated!! :bow:

 

Mark

Decide where you want to fit/locate the electronic sender unit (in the engine bay or behind the dash etc), run a 4mm vacuum hose from the sender to the Vacuum line on the standard sender located at the rear of the engine on the left hand side, insert a ‘tee’ then connect the sender to the gauge and power it up