As above, how do I? and is there any special tools involved?

 

Thanks guys.

 

Steve

Firstly unwind the 10mm nut on the lever to slacken the cable then remove rear wheels and pull the little grommet out on the disc, turn the disc round so you can see the adjuster through the hole, click it up/ down( can't remember which) with a little screw driver till the disc locks, then back if off 3 clicks. Do this for both sides, then wind the 10 mm back up so you have a little bit of freeplay in the cable and job done. Oh then put the grommet back in the disc and put the rear wheels back on. :D

:bow: Cheers for that there was me just going to wind up the nut on the lever inside the car :x: i suppose that would stretch the cable then :headvswal

winding up the 10mm nut will not give a true handbrake feel, and can overstretch the cables.

Handbrake and shoe adjustment procedure in the online manual:

 

http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=br&dir=&config=&refresh=&slide=21&cycle=off&scale=0&design=default&total=56

 

-Andrew