Hi Guys before i start ripping the inside of my car apart can anyone tell me where the ABS ECU is situated on a SWB as im fitting a Racelogic TC,so any advice on wireing etc would be a great help.

Thanks

Steve

LWB is behind the o/s/r inner trim if that helps!!

Under that plastic trim just behind the driver's headrest.

Thanks guys

Jphn i looked there but all i could see was the ABS pump with the bleed valves.

Oh, yes sorry, think it's down below the actuators and stuff. I can check on mine soon if you don't find it before then!

Thanks John i was going to fit today it today but the weathers turned Kak and im still not 100% sure on the injector wires LOL.

Try this, you can see the ecu and the pin out numbers clearly...

 

good luck

 

 

http://www.300zx-twinturbo.com/cgi-bin/manual.cgi?list=diag&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=1&design=default&total=4

Cheers mate Racelogic have sent me a diagram but te fact that i have to solder 20 wires together is a bit daunting LOL and theres not much room down there.

Stu's site (SMW1) may be of some help. (tho it relates to a 2+2)

 

http://www.300zx-mods.co.uk/TractionControl.htm

Cheers mate Racelogic have sent me a diagram but te fact that i have to solder 20 wires together is a bit daunting LOL and theres not much room down there.

 

if you lived near i would help you do it ??? (i am an electronics eng).

Thanks Guys.