im having a spot of bother with saftey boost as some of you are aware, just bought the car so dont know much of it history or mods,

 

ive got a apexi air fuel digi controller in the car and a apexi digi boost controller, the boost is set at 0.9 kg/cm but only boosts to 6.8... the air fuel thing is set at 0 and goes up from 0.+3, +6, +12 and so on..

 

have a aftermarket gauge and shows the same as the boost contoller when boosting, the standard gauge goes over to +14 when boosting...

 

 

looked under bonnet and found the black square conectors to be still connected ( standard boost controll soloniods)? so i un-plugged them.

 

ecu reads code 55

 

 

found the apexi controll unit under bonnet and one side is conected to the vacume system but the other side is not conected to anything? is this normal

 

im a little confused and dont know what to do next or if its all connected up properly?

 

help :confused:

just been reading the dutch 300 site and it shows on the avc tech install that both the ends of the avc soloniod are conected to the vacume system, can anyone help with my problems?

Just been outside with torch and the stock boost hose i think... have a large blanking screw in the end of the hose both sides??? arnt these supposed to go to the other side of my avc soloniod?? or are they supposed to be blanked??

anyone?

wish you could post some pics. would make it a tad easier

will do tomomorow, thanks

here are the pics of my situation i think its all unplugged the hoses where the screws are, i think there supposed to go into a t-piece and then to the out side off the avc solonoid?

IMGA1587

pics havent come up buddy

here are the pics of my situation i think its all unplugged the hoses where the screws are, i think there supposed to go into a t-piece and then to the out side off the avc solonoid?

IMGA1587

 

it wont let me post them up?

where are you too there is bound to be a zed specialist by you that would have a quick look ?

your going to have to subscribe to get the pis up or email them to me at crazychef@hotmail.co.uk

your going to have to subscribe to get the pis up or email them to me at crazychef@hotmail.co.uk

 

you have e-mail

 

thank you...

didnt receive the email m8

have tryed again

ok heres the pics for you all to help this guy out

have highlighted the areas that show the hoses

;) cheers buddy a great help, dont want to sound not greatful....but youve circled the wrong bit in pic 3..... its the unconnected soloniod end (out it has writen on it)

 

sorry..and thanks agian. ;)

ok here ar the pics again un-edited hope thats better

cheers z evo guy, can anyone help??

does no one know anything?, do i just connect my apexi boost soloniod to these two blanked hoses.....?

 

any help is greatfull....