Going to start to replace the O ring seal at the back of the gearbox today but not looking forward to it :cry:

Advice so far :-

 

1 mark the prop shaft as it is balanced

2 use a special tool to remove the seal ,not got one so screw driver will have to do :rolleyes:

3 make sure you put the seal back in straight ,block of wood :smash:

 

anymore

Going to start to replace the O ring seal at the back of the gearbox today but not looking forward to it :cry:

Advice so far :-

 

1 mark the prop shaft as it is balanced

2 use a special tool to remove the seal ,not got one so screw driver will have to do :rolleyes:

3 make sure you put the seal back in straight ,block of wood :smash:

 

anymore

 

 

if you remove the old seal neatly you can then place the new one in and use the old one to knock it in. place on top of old one in other words so it goes in straight,dont forget a smear of silicone around the seal so you get good sealing and extra precaution!

fork that for a job

 

phoned century garage who does the work that I hate asked how much to do this job £50 :dance: .Why should I get covered in shit for that kind of money