Hi. Just wondering of it's ok to share the same signal vacuum hose I use for my Profec B that is routed in behind the centre stereo facia, for the sensor for my Greddy Electronic boost gauge, having them both tee'd together and sat next to each other.

 

I thought about plumbing them separately but firstly I didn't want to run anything else through the bulkhead if I don't have to, secondly I thought It'll just be another potential leak point if I do, and finally, that the plenum is covered in vacuum lines that are tee'd into each other and split off in various directions anyway...

 

Is this ok to do this? I was just worried about one interfering with another, causing an innacurate measurement of the boost.

 

Cheers

 

Derek

Don't think it would cause any problem.

Ta! That's saved about 2 hours work then. ;)