As per the "what did you do" thread I had to source a pair of replacement front calipers today, as mine have seized on the lower inner piston on both sides. After searching the 'net, I found a couple suppliers had them in stock. First being Torquen - albeit at over £600 for a pair for either cast iron or aluminium.. Then I found some fully rebuilt aluminium ones (the correct fitting for a TT) at less than half that, which got me thinking. Cast iron vs aluminium....?? Both seem to have their merits and drawbacks - the ali ones being much lighter, so less unsprung weight - whereas the iron ones allegedly handle the heat better, reducing the chance of disc warpage. If one believes everything one reads on the interweb LOL! Seeing as I don't track the Zed - and I am happy with the OEM set-up, when it works properly, plus I have a set of Brembo discs waiting to go on, as opposed to the Ebay ones I had previously, I thought the ali calipers would suffice. Opinions please - good or bad😁
By
RichardS · 1 hour ago 1 hr
Went today!
Took a stack of photo`s and put `em on me site.
Be patient though.Takes a bit to load up.
Put some more of me new 200SX up there too with me front lower bumper sprayed too match rest of car and to emphasize the front bumpers size.It WAS black and about 5 inches at the bottom was invisible.What a waste of lovely large bumperness!
DAVE http://www.mcmahon32.freeserve.co.uk
[This message has been edited by dave mc (edited 21-07-2001).]
[This message has been edited by dave mc (edited 21-07-2001).]
[This message has been edited by dave mc (edited 21-07-2001).]