Skip to content
View in the app

A better way to browse. Learn more.

300ZX Owners Club

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Touch and go to get my zed to the NEC

What a weekend i've had.

An emotional roller coaster, and you could say i've had 4 seasons of emotions in less than the first 3 days working up to the weekend.

You all know i've been prepping my zed which has been an ongoing project for nearly 10 years now.

Well i managed to get it partially tuned enough and ready for its MOT on the 5th November and it luckily passed.

Then the Zed was fully machine polished and coated using Angel Wax which made the paint just look superb.

At the same time as doing the zed i also had a 18ft tilt trailer i could use which over the last month i fully refurbished with new electrics,

lighting, buffalo board and the last to be done was the wheels.

2026-10-28 16.39.02.jpg

2026-10-31 14.06.22.jpg

2026-10-31 11.16.23.jpg

We came so close but the wheels never arrived,

2026-11-09 15.55.04.jpg

and i had to do an emergency call out to friends and managed to secure and collect a trailer.

2026-11-10 12.57.44.jpg

Featured Replies

  • Author

All good with the trailer now it was Tuesday the 10th and we started to load the zed onto the trailer.

So i start the zed in the lockup and proceed to drive 15 metres forward and turn to the left and align the wheels with the trailer.

Then disaster truck, not even 2ft away from the ramps and near enough in perfect alignment i heard a pop and bang.

A clatter of metal which only can be described as a soul destroying sound as any sound of metal on a rebuild where every part

has been pain staken'ly replaced and checked and even passed its mot.

On inspection; everything looked ok until i realised that the front wheels were pointing in two different directions.

Something was seriously wrong with my front right and this was confirmed after i removed the wheel.

2026-11-10 13.52.15.jpg

For no apparent reason the tie rod ball had popped out its socket, which i didnt believe could happen.

These parts were now 8 years old but in terms of usage they were like brand new and had no millage on them yet.

2026-11-10 14.15.50.jpg

I'm so lucky that this disnt happen a few days earlier as it would have been game over as i went a trip to collect my kids and back.

Luckily i have my own breaker so i jacked that on up and removed the 30+ year version to replace mine.

Back to my zed i aligned the rod as best a could and put the wheel back on.

  • Author

Next issue we discovered was the ramps even with planks of wood were too steep and my zed was too low.

So off with the front bumper, and we slowly cranked the pully and brought the zed dangerously close to curbing the wheels.

As the we found that my zed has less than a few cm's at each side to get on, so we used cut down carpets to protect the alloys.

All in the exercise took about 4 hours assisted by my brother in law, but we got there in the end.

2026-11-10 17.26.20.jpg

After the zed got to the top of the ramps we were so lucky as my zed just got on and no more.

Even if the zed got up the ramps with the front bumper on it would have never of fitted due to the length.

  • Author

The day of the shows build up has arrived and with a little help from onlookers i got the zed back off the trailer safely for 10:30

2026-11-12 10.36.30.jpg

However, the steering damage has now miss aligned the wheels and o my, it was hard to get it to go in a straight line.

But i managed to crawl round in the queue of other classics to hall 5 and became the first of our stand to arrive.

  • Author

Jay arrived within 10 minutes then i noticed Richard had already brought in some of the stand banners and flags.

2026-11-12 10.57.02.jpg

We marked out the floor using official tape purchased from a NEC store which turned out wasnt official or even approved - go figure.

So had to rip that back up to avoid getting fined.

2026-11-12 11.20.26.jpg

With the Zed positions agreed apon, the cleaning and polishing commenced.

2026-11-12 13.36.28.jpg

The images below look better than to be believed as the whole car had a filthy layer of dust and residue from the trip down.

2026-11-12 13.50.23.jpg

  • Author

Day 2 by our calendar, the show opened and the amount of interest in my Zed was very emotional, and i partially lost my voice for a bit.

I simply did not comprehend how many comments i would get on the colour, wheels, look and the back story of this zed.

2026-11-13 15.22.18.jpg

Better still, Lancaster included my zed in a official video.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.