Pistons and rods installed. Just waiting on a set of STDX King rod bearings to make some adjustments to my big end bearing clearances…. Unsurprisingly, the STD size bearings EPR used produced 0.0017” clearance not the 0.0035” quoted in the build sheet. Targetting 0.0025” for this build. Also reinstalled the @brettdempseyengineering oil tree. Oh and I will never use a ratchet piston ring compressor ever again, these ring compression sleeves are SOOOOO much easier to use!!
By
nickz32 ·
Hey Guys,
What are the main gaskets under the plenum called and where can i source them from? i know there is the main one in the middle.
http://www.conceptzperformance.com/Cart/description.php?II=677
how about the ones on the sides, what are they called?