Hi Guys, after suffering a ramp dismount, i have got the car back up on the ramps and the gearbox is now under the car awaiting lifting and securing. However..(here it comes) i seem to have mislaid the small tub that held the securing bolts. So does anyone have any idea of the size/length/type that i need.

 

Regards

 

Rich

Are you talking about the bell housing bolts?

are you putting in a auto or manual box? I have my manual conversion in a garage in whaddon at the moment

Look in the service manual it lists them what size and where they go.

Hi Guys, sorry for the delay, bell housing? yeah, i think thats what i'm on about, i'll see if i still have a pdf of the SM.

 

CB, its a NA Auto, Whaddon!! you're kidding..thats about 400yds from me, i live just off whitecroft road, which goes past Eternit.

 

Rich

online manual is here pal : http://www.300zx.co.uk/cgi-bin/manual.cgi

 

And I think this link will work, but there's 2 different gearbox types, apparently, mine's been a manual for ages, so unsure about that, and it doesn't tell you the size/thread, but someone should easy be able to tell you that, infact, I know they are bog standard M10 for a start, so that's probably 1mm pitch, hope it helps....

 

http://www.300zx.co.uk/tech/manual/manual/at/097.gif

online manual is here pal : http://www.300zx.co.uk/cgi-bin/manual.cgi

 

And I think this link will work, but there's 2 different gearbox types, apparently, mine's been a manual for ages, so unsure about that, and it doesn't tell you the size/thread, but someone should easy be able to tell you that, infact, I know they are bog standard M10 for a start, so that's probably 1mm pitch, hope it helps....

 

http://www.300zx.co.uk/tech/manual/manual/at/097.gif

m10 standard ( m10 coarse) is a 1.5mm pitch m10 fine is 1.25 pitch

Edited November 25, 201213 yr by hellraiser

can buy them as a kit from http://www.conceptzperformance.com/cart/description.php?II=2735&Car_Type=NIS300&UID=2011020117164966.249.67.154

I got mine from a nuts and bolts place just watch out though because stock ones arevan mrb as gaz said with a rdmm head, they will supply you with a 16mm I think head. Just take one in with your list of thread lengths match them up.

I'm in Cambourne but my brother rents one of the council garages in the village. I won't be fitting the gearbox for about six months so if you need tyre bikes you can have them and just replace them by then