I got racelogic traction control in my car. I got one yellow wire left to go to injectors.

How i should connect is just a one wire but its six injectors.So how should I do?

Here is the generic install guide from Racelogic themselves:

 

http://www.racelogic.co.uk/images/stories/other-prod/Traction%20Control%20Manual%20v3_2.pdf

 

and for the Z32:

 

http://www.twinturbo.net/nissan/300zx/tech/tc/tc.html

 

-Andrew

Edited October 30, 201213 yr by AndrewG

J seen this page before but my tc is a bit ol and its got only one wire which needs to go to injectors, its a one yellow wire and i got six wires to defferent cylinder what i can do connect all of them to one yellow wire to traction control unit?

I'm confused... from the instructions it looks like you should have at least two wired to be inserted into the injector feed to redirect it though the traction control unit.

 

are there different models of this unit? was it pre fitted or have you just put it in yourself?

You seem certain of the use for the yellow wire? If you are working from "instructions" for the unit you have please post them up.

I'm not aware of an older model of RLTC than the one I have had for over 12 years (but it is possible). The RLTC I have intercepts

each injector signal and controls them individually when working (not as group which you seem to suggest is the case with your

unit).

 

-Andrew

Edited October 31, 201213 yr by AndrewG

 

this is a traction control I have its racelogic, as you can is there is a plug goes inside ECU there is blue green red connected allready on Ecu but yellow needs to go to the injectors but there should I connect, may be somebody got the same tc ?