clutch alignment tool, been looking for 1 and can only seem to find them for sale in the USA any suppliers in the UK that any1 knows ... cheers

clutch alignment tool, been looking for 1 and can only seem to find them for sale in the USA any suppliers in the UK that any1 knows ... cheers

 

http://www.toolshopdirect.co.uk/item.php/site/froogle/sn/AK710 :wink:

i got a universal from halfords worked on my twin plate too with a bit of playing about

Halfords sell half inch extension bars and insulation tape,i use me eyes but the latter will suffice and do just as good a job as any alignment tool.

as above, half inch extension bar for me. Or depending on the car i split the box 2 inches and use the super glue technique

I use a drumstick with gaffer tape, but on the zed, I have a jack handle, which is thinner one end so it can go inside another jack handle, perfect size to fit in the spiggot bearing, then gaffer tape around it for the friction plate, quite often if you buy a new clutch it will come with one, but not always...

I did my twin plate by doing the nuts on the clutch until the friction plates just caught enough to be a bit stif but move, roughly lined them up by eye, then wiggled my gearbox on to line it all up, carefully removed the gearbox again then tightened up all the nuts on the clutch......this was off the car ofcourse!

I'd be willing to lend you my one if you would promise to send it back to me.......

Got one here mate.......lent it to welsh z last year, pm me your details and I will post out to you:cool3: