This may be a simple job but I can not see how to remove the headlight unit.

I am having trouble adjusting the low beam spots so would like to remove the whole unit so as to see what the problem might be.

Can anyone help explain how this is done please?

bumper off is easier way i find but it can be done while on just makes two screws harder to get too

http://www.zmods.org/index.php?page=headlight_rem

Your plastic drive adjust cogs could be broken, this is very common.

If you need some of the metal ones to replace just pm me as I do have some.

Thanks ck300z,

not sure I could cope with bumper off again!!:sweatdrop::smash:

I think I might try with it on, even though as you say, easier with it off.:blush:

I think I may be regretting that decision already.:wacko:

Thanks also groover,:thumbup:

nice link! very helpfully.

As they say, a picture paints a thousand words.

This may be a simple job ?

 

i found the 1st plenum was easyer :lol::lol::lol::lol:

2 bolts from above, and 2 from below You can get in via the nose panel, indicator slots and inner arch. I would'nt remove the bumper personally, it helps with access a little but its a lot of extra work.

I managed without removing the bumper. Do you have a young kid you'd be able to get to help? Small hands would definitely help...

My wife helped with mine and I managed quite easily with the bumper on :cool3:

 

For the record and in an earlier post, I have sold all my Tamiya cogs to redwine300.

Cheers guy's,:thumbup1:

 

Looks like my eleven year old daughter may be helping me with the Zed then.:hammer: