Been looking for a flypress for a while and final got one. For people who dont know these are used to bend and punch holes in sheet metal amoung other uses. Ordered some angle iron last week and made and stand for it now ready to rock an roll.

 

 

Just start my first job for my new press. I have to make 5 floor panels 1200mm x 760 for the local church baptism pool. The pool is sunken into the floor and when not in use is covered with these floor panels. The old ones were made of wood and to heavy for the people to lift in and out so im making some light weight ones out of aluminum.

 

 

Got a few more jobs lined up and then i might start making a few bits for me zed :thumbup1:

Bloody hell, its some size !

just over 1/2 a ton with a 11" throat. The engine crane just managed to get it up on the table which is just over 900mm tall.

just over 1/2 a ton with a 11" throat.

 

Sounds like my buddy's ex missus.

We have the exact one at work, also a broaching press. where do you get the punches from?

Sounds like my buddy's ex missus.

 

shame she was big thats a waste of a good talent :tt1:

We have the exact one at work, also a broaching press. where do you get the punches from?

 

just what i've collected over the years. Are you going to send me some :wink: