I'm looking to see where exactly the original boost solenoids are, I've looked at a few pics but none highlight where precisely they are.

 

Also I'm wondering where most people have chosen to locate the solenoid box when fitting their BC...

 

Pete

factory ones are in the middle at either side of the engine below the plenum you will see the electrical connector coming off them should be held in by 2 screws and a bracket. I have put my blitz single solenoid up behind the brake master cylinder on the right there is 2 bolts there and i used one to mount the solenoid. This makes it easy to get lots of reach on the harness in the drivers area as well.

 

Marty

Where did you feed your harness through? Looks to be simpler on the passenger side to me?

Not having the full instructions, I'm wondering if it would be ok to pick the 12v feed up from the stereo supply, or does it need to be fed elsewhere? What have you put your settings to on the controller?

 

A lot of Q's I know...lol

 

Pete

i put my harness through the bonnet cable grommet. I took my power supply off of the stereo as well used ignition pos think its the blue wire and all my settings i took off of this site as well you will have to start low and then just build it up slowly and watch your peak boost that the BC will record

 

http://www.300zx-twinturbo.com/tech/blitz/blitz.htm