Hi all i need some help to put in my delimit chip in cos zedworld did not send me the wiring diagram for it. If any one knows where i can see one on the net or tell me how many thanks

Speedo delimiter wiring guide>

 

http://www.300zx.co.uk/forums/showthread.php?t=117157

 

Chris ;)

thanks m8 the thing is my one has red. yellow. black. green. grey. coming out of it ?

Not sure on the green or grey, mine was done upon purchase sorry but am sure someone will now poss groover? , have you tried calling Jeff also ?

The green replaces the violet in the description, iirc the grey can be left off, its a signal for something else, which im damned if i can remember at the mo, its been so long.

If you bought it off Jeff then he will be able to tell you exactly

 

Cheers

Graham

Just IM or call Jeff and he will sort you out!!

i have been on the phone to zedworld and asked him to email me and send it out and i have still not got the wiring info plz can some one help me i need to know so i can get my 300 done plz plz help

Hi all i need some help to put in my delimit chip in cos zedworld did not send me the wiring diagram for it. If any one knows where i can see one on the net or tell me how many thanks

 

Red cable +12 volt

 

Black -0 v

 

Green To speedo input

 

Yellow To Speed sensor

 

Grey Not used

 

 

Identify the green / yellow cable on the rear connector to the speedo cluster.

 

Follow this onto the pcb board, the strip of copper can be cut with a sharp knife, on the connector side of the cut solder the yellow cable to the strip. That leaves the other 3 cable to be connected using the screws that are in place connecting the speedo unit to the board.

 

There is a 12v (red cable) 0v (black cable)and speedo input (green cable) this are marked on the pcb.

 

I will post a photo here tomorrow to show this in detail.

 

Jeff TT

thank u very much :)