Well a rather annoying twist in the tale. Installed the crank the other day after completing all pre assembly prep. Everything seemed ok bar a slight bit of clearancing needed on the girdle plate. Took everything off and found a whopper of a scratch on one of my main bearings. Annoyed doesn’t come close!
I know the block and crank were crystal clean so I can only assume that my old pot of assembly lube had become contaminated with a bit of grit or who knows what. What are the odds?!?
So, yet again, a thorough clean of block and crank before sealing away on clean bags while I await new bearings to arrive….. and a NEW bottle of assembly lube by @torcousa via @nimbusmotorsport
By
nickz32 ·
My Speedo is displaying MPH but seems to be reading KMH. Could this be down to some sort of sender relay
The fuel cap is not opening from the lever......Now sorted
And the boot release is working but the lever has to be held up at the same time as lifting the boot
And lastly I need the following repaired. Anyone know if it's much of a job.
And the cigarette lighter is not working (Bummer for the sat nav) Scratch that one now fixed
Cheers
Edited by Tango450