...vacuum feed pipe (6mm) from my mechanical boost gauge to the balance bar? I know a lot of people have rooted wires through the bonnet release wire grommet on the bulkhead, but I didn't want to put the vacuum pipe through there as it looks a bit tight. With oil and water wires already going through there, I'm worried it may kink the pipe?

 

Is there another way I can feed this pipe?

Cheers for any help

Dave

Mine goes down the passenger side wing, through the rubber grommet, past the ECU and to my center console :)

Mine goes down the passenger side wing, through the rubber grommet, past the ECU and to my center console :)

 

that's a good idea! Cheers mate :duffer:

that's a good idea! Cheers mate :duffer:

 

Np mate!

 

Its very simple to install, just remove the wheel and the wheel lining and it will be very simple :)

Np mate!

 

Its very simple to install, just remove the wheel and the wheel lining and it will be very simple :)

 

I'll do that tomorrow. cheers

ive got all my wires through there,

 

oil temp, oil press, boost, and the amplifier power wire,

 

all work fine :smw: