Can anyone tell me where there is a 'how to' to do this? There is a link in the FAQ section but don't work, I was reading one just the other day, but can't find it for the life of me! Cheers...

Scratch that post, just found it and switched my oven on, this should be fun...

Use a hair dryer, much safer and not so hot, if you are not careful you could melt the plastic or crack it as you pry it apart.

Just done my first one, no problems with the oven, turned it face down for a minute or so too, that was a big help, came apart no probs...

 

Put my clear diffuser in, put it back together, but wasn't happy with the positioning of the diffuser, so heated it back up again, and prying it apart, chipped a piece of the outer face off! There was some serious bad language in my kitchen I can tell ya...

 

I think I can repair it so not really noticeable with some black epoxy resin and some patience... Ah well, at least the next one will be right! (famous last words) :-)

Good effort for trying, when i did mine i did the oven way, no probs getting apart. When you do put back together, make sure that you heat the black sticky stuff up and get a good seal, or you will get moisture in the lenses.

Had to re do mine again.

Will do matey... Second one is done, did it slightly different, glued the diffuser in place, jusr waiting for it do dry, then back slaving away in a hot kitchen :-)

Make sure its dry!

 

I did this once and the fumes from the glue stained the lens, you couldn't see it untill back on the car!

I used a few blobs of epoxy resin, it's sat here next to me watchin a Steven Seagall film, dryin off nicely, so at least one of em will be right! Cheers for the tip mate, I'll bare that in mind! :-)