spritley56

there just seems to be a rather large part of the loom in the way and it wont move my hands just dont seem to fit

think my hands are too big to get in too many wires and tubes is nothing on these cars staight foreward to do

got my bulbs for main beam but cant get to the old ones to change do i have to remove the complete light unit to do this job or is there another way of going about it any help please

cheers for that richard will go with the osrams as you suggest then

so if you were buying for yourself which would u recommend as the osrams are a lot cheaper or is it the case you get what u pay for

no not me someone else

cheers lads thought it might be a good deisel

thanks for doing the link groover can u tell me how to do it for future reff

seen this on ebay thinking of having a dabble http://www.ebay.co.uk/itm/110749811372?ru=http%3A%2F%2Fwww.ebay.co.uk%3A80%2Fsch%2Fi.html%3F_nkw%3D110749811372%26_sacat%3D0%26_odkw%3D300zx%26_osacat%3D0%26_trksid%3Dp3286.c0.m270.l1313%26_fvi%3D1&_rdc=1 with this description any idead of what could be up with it before i bid says its been to z world reg num is h987 avo Being sold as spares or repairs - it blew a water hose and the engine temp went up to 3/4 of the way up (didn't hit the red, the needle was half way between centre and the top) and when I put the heaters on hot and full the temp went back to normal. Also made a rattling noise like a diesel at certain revs, I drove it home about 3 miles very slowly and the next day tried to put water in it and it just leaked out the bottom somewhere. I'm done with it - being sold for spares or repairs

seen this on ebay 200595358133 is this what i need

taken apart deff socketed

do the new chips plug in or do they still have to be soldierd as well

cheers for that lads

can someone post a pic of a socketed ecu as im not sure about mine

hi are there any specialist tool i need to remove a socketed chip from the ecu

there is a adjusting screw on my ecu can anyone tell me what its for or does

gave it up as a bad job just couldnt move the pump will leave it for someone else must admit defeat on this one lads

no is that the pulley where the belt goes round and which way does the pump go is it towards the centre of the car

trying to change the power steering belt got the adjuster nuut undone but cant get the actual pump to move to get the belt off im working from under the car isthis the wrong way to go about it asm getting frustrated now at what should be a easy job any advice or diagrams will be helpfull please lads

have been reading threads on light upgrades i have hid fitted as dip beam but am told they are not recomended for masin beam but to use osram nightbreakers instead can someone enlighten me on this also what type of bulb to buy for eg h1 h4 h7 etc

cheers lads will check it out tomorrow dont supose any one with a spare one if i need it please

any pointers to which plastic boot panal

it is on the left as u face the dash in the bottom corner and shows up like a light beam am i on the correct one and why is it intermitant can anyone give me a link to a diagram of the uk spec dash as i dont have a manual please

i keep getting a red light on the bottom righthand side of the dash when i press the brake pedal this seems to be intermitant it looks like a fog light warning but it is red can any one help as i do not have a manual to go by

ok cheers lads anyone recomend a place to buy braided fuel lines and are they easy to fit