My left side indicators have stuck on, I've tried turning the alarm on and off over and over but they just stay on.

Where is the flasher unit and relay located so i can take them out to check them please?

Just a quick suggestion if you have'nt already tried it. Alot of indicator problems relate back to the hazard switch. So give that a wiggle etc.... :)

Just a quick suggestion if you have'nt already tried it. Alot of indicator problems relate back to the hazard switch. So give that a wiggle etc.... :)

 

Tried it, didn't work, cheers though.

Edited August 18, 200817 yr by Gezzmarrelda

bump

Could be a dirty contact on the relay or even the relay itself. Try pulling it and putting it back in

Could be a dirty contact on the relay or even the relay itself. Try pulling it and putting it back in

 

I refer you to my first post which asks "Where is the relay?"

http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=el&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=112&design=default&total=133

Cheers vijay. Not looking forward to this

but how could it be the relay if it's just one side?

I refer you to my first post which asks "Where is the relay?"

 

:slap:oops! sorry mate didnt notice that bit:)

It turns out it's not, took the dash off cleaned all the contacts from the front to the back but it stayed on so i think I need to rip the alarm/imobiliser out completley.

it must be your alarm wring as it only does it once you have set the alarm doesnt it ?

My hazards have not been working since i bought the car and i still havent managed to figure out why :(

it must be your alarm wring as it only does it once you have set the alarm doesnt it ?

 

Yep, this time they've just stayed on though.