Anybody got a pic of how to wire this into the ECU on a z32? My instructions are in japanese :(

as it happens mate YES.....well sort of. Just looking for info about them.

 

This is for the 240sx but might be some help:

http://www.240sx.org/faq/articles/apex.htm

 

and this is the pin layout of the ECU:

http://www.300zx.co.uk/forums/showthread.php?t=79861&highlight=ecu+harness

 

Hope this helps.

Tom

White = 27 Mass Air Flow Sensor MAF

Brown = 42 Camshaft Position Signal (Down as Crank 1 sensor in manual)

Pink = 1 Ignition 1 Coil #1 (No 1 Ignition Signal in manual)

Blue = 41 Camshaft Position Reference Signal (Crank 120/180 signal in manual

Orange = 101 Injector 1

Black = 26 Mass Air Flow Sensor Ground (Ground in manual)

Red = 59 Power for ECM (IG Power in manual)

Green = 53 Vehicle Speed

Grey = Only used if removing speed limiter

Light Blue = Not Used

 

Ediited to correct

sounds about right to me compared to other electronic devices but couldnt say for certain.

 

Is that how many wires need to be connected then in total, 10?

 

Where are you going to mount yours. Would it be possible to post up some pictures of the instal and how the fitting went and what you reckon of the unit when you have got it all plumbed in and tried it out?

If i dont blow the car to kingdom come mate lol