Can anybody please tell me where the conector's are that go from the wire that goes through the bulknhead/ inner wing (in photo) as i need to take the wire that goes through the front of the inner wing out so that the pannal can be repaird right in stead of bodging it up.

thanks graeme

not sure what you mean fella,

 

this any good to ya :confused:

i nedd to take the wire out from across the wing and under the light bucket. I've circled when it goes through the bulk head, Would like to know where they go to inside the Passanager foot well and how easy/hard they are to get out.

bump

If you mean where does that big connector go inside it's down to the ECU on the inside under the passenger floor board and the other end goes to all sorts of stuff in the engine bay :confused:

thanks i did have a quick look in there but the light was crap and i think i'd had enough, wasn't sure if it went to many different bits in the foot well/behind the dash board

thanks graeme

It goes to all sorts of stuff really.

Won't be an easy job to remove.

:cry: :cry: :cry: I was hoping that someone wouldn't say that :cry: :cry:

just spoke to the man at garage and he said it's got to come out really, even said about cutting them half way down the wing then re-joining them and heat shrink wrapping them after :confused: :(

can anybody else shed any more light on this problem.

as to where in the footwell or how many ways it spilts behind the dash.

would cutting the wires be a bad idea.