Just got a HKS t piece to fit a hks water temp gauge was going to fit in the top hose but i looked at the hose and it has no straight runs in it loads of bends .has any one fitted one to the top as this is a more acurate reading than the bottom hose .thanks :cool:

I've fitted to the top water hose to the rad. Gotta do that one as its coming out the engine. Other hose is going in so no good.

I had one fitted but because you cut out a fair bit of the pipe and also the pipe isn,t the same diameter at each end , you have to over tighten the rear most jubilee to pull the pipe tight and after some it split on me , lucky for me i was near the Zed Centre and luke had a spare :bow: :bow:

In the end i had a boss welded on the alloy pipe and got it drilled and tapped to suit , only cost a few quid :dance: