More vids, even better this time!

Followers

April 1, 200223 yr

100+mb more vids uploaded. Some all-time greats this time. Loads of big hp dyno runs, shit I'd be happy with half the power some are making!! Some cool street racing in the cars that were on the dyno, and also some bike action. Have a look at the GSXR 600 turbo, and tell me bikes are slow!! Again some track action from Tsukuba circuit with a GOOD recovery from R33 driver!!!

Have fun people!! http://bagpuss.swan.ac.uk/dunk300zx/

RCD

------------------

Quote

April 1, 200223 yr

That 6R4 crash.

Thats my mates dad that was. Hehehe. No joke. Lyndon Barton. Its up and running again but I think he has a new one.

Quote

April 1, 200223 yr

Author

Stuart! Get him to sell me the salvage from the crash, I've always fancied a 6R4

Seriously though, how long ago was the crash???

RCD

------------------

Quote

April 1, 200223 yr

3 years ago. All that was salvageable is on his new one now. The rest has gone.

Quote

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.

Reply to this topic...

Followers

Go to topic listing

No registered users viewing this page.

No registered users viewing this page.

Check engine light comes on and off sporadic.

P0400 indicates an EGR Flow Malfunction. The ECU has detected that the Exhaust Gas Recirculation system is not flowing the expected amount of exhaust gas back into the intake. On the Z32, this is frequently caused by carbon clogging the EGR tubes (especially the one running under the plenum), a failed BPT valve, or a stuck EGR valve itself. It can also be a vacuum leak in the lines controlling the EGR.
P0136 refers to the Oxygen Sensor Circuit Malfunction for Bank 1 Sensor 2. Bank 1 is the right side of the engine (passenger side on US LHD models, driver side on RHD), and Sensor 2 is the rear sensor located after the catalytic converter. This code usually means the sensor itself has failed, the wiring to it is damaged (burned on exhaust is common), or the connector is corroded. Since it is the rear sensor, it monitors catalyst efficiency rather than air-fuel ratio, so it likely won't affect drivability as much as a front sensor would.
P1150 and P1155 are manufacturer-specific codes for the 1996 Twin Turbo. These refer to the Wastegate Valve Control Solenoid Valves. Since you have a Twin Turbo, you have solenoids that manage the wastegate actuators to control boost pressure. P1150 typically points to the wastegate solenoid valve circuit, and P1155 is often listed for the same system (possibly distinguishing between the two solenoids or a specific electrical fault within them). Seeing both simultaneously suggests a potential electrical issue common to both solenoids, such as a shared power supply fuse, a ground issue, or a disconnected harness in the engine bay near the boost control solenoids.

By Dazsw · 6 hours ago6 hr
Hi all - New (returning after 20 years)

His last z was a good example.Keith does personal imports & I have no doubt this one will be a good buy also.Let us know how you get on !

By jimmer · Yesterday at 12:031 day
Hi all - New (returning after 20 years)

3 hours ago, jimmer said:Hi Fella,Welcome back.It just so happens Keith Bailey who has been a customer of mine with his last Z has a manual car he imported less than 2 years ago for sale.It is silver,Rust free & bog standard.His no is 07808924417
Hi Jimmer,

Thanks for the advice, ill drop him a call.

By Wolfpack · Yesterday at 11:511 day
Wipers and Washer issues

Hi Joel - and welcome back!
This is the main relay - they are NLA from Nissan so it might be worth buying another to swap, just to confirm whether it's the problem.
NISSAN 300ZX Z32 TWIN TURBO VG30DETT WINDSCREEN WIPER RELAY MODULE | eBay UK
Failing that, it could be the switch itself; you may need to replace the LH control pod.
Richard

By RichardS · Yesterday at 09:541 day
Simply Japanese at Beaulieu 19th July 2026

Fingers crossed Steve......😁

By RichardS · Yesterday at 09:261 day

Sign In

More vids, even better this time!

Featured Replies

Join the conversation

Recently Browsing 0

Recently Browsing 0

Popular Posts

Check engine light comes on and off sporadic.

Hi all - New (returning after 20 years)

Hi all - New (returning after 20 years)

Wipers and Washer issues

Simply Japanese at Beaulieu 19th July 2026

Important Information

Account

Navigation

Search

Configure browser push notifications

Chrome (Android)

Chrome (Desktop)

Safari (iOS 16.4+)

Safari (macOS)

Edge (Android)

Edge (Desktop)

Firefox (Android)

Firefox (Desktop)