My car has one of Luke’s converters and the Speedo and steering is fine (in the paperwork with the car was Luke’s simple instructions for wiring in the converter, so I guess that it was done properly).

 

My problem is that when I connect Datascan, the car is sending it KM/H rather than MPH, really frustrating as to do say a 0-60 speed test, I have to set Datascan to KM and do a 100 KM/H test, is there anyway that I can change this to MPH?

in options there is a function to swap from MPH to KPH mate.

As mentioned that's what I'm currently doing, I was wondering if there is anyway I can get the car to send in MPH to Datascan?

Becuase of the Crude way MPH convertor alters the signal from the speedo it will be read incorrectly by anything else that reads the speed (Datscan, PAS, HICAS, Cruise), but if you Set Datascan to KPH, and it will acutally display the speed in MPH (although it will say kph, it is in fact mph)

Becuase of the Crude way MPH convertor alters the signal from the speedo it will be read incorrectly by anything else that reads the speed (Datscan, PAS, HICAS, Cruise), but if you Set Datascan to KPH, and it will acutally display the speed in MPH (although it will say kph, it is in fact mph)

I hadn't even thought of that problem. :rolleyes: :headvswal