Had a suprise this morning when three large cardboard boxes arrived on my doorstep (thank Christ someone was in to carry them what with me and my dodgy hip at the moment! Lol! ;)). After a bit of unpacking it turned out to be a load of car audio goodies sent by one of my sponsors Matt from Nearfield Audio!

 

 

And after a bit more unpacking :D :

 

 

Basically the set-up consists of the following:

 

1x KAR 400.2 amp

1x KAR 1000.2T amp

2x KAR 10D subs

1x KAR 265 comps

(plus a HUGE roll of sound deadening material! :D)

 

The subs, amps and comps look fantastic but to be honest I can't wait to see how they match up to their spec list:

 

KAR 10D

Dual voice coil 4 ohm 200 watts rms / 400 peak

Large rubber surround

One piece injection molded cone

High temp Kapton Voice Coil

Large diameter flat spider

Chrome extended bump plate

Impedance : 2 or 8 ohm

Resonant frequency : 28.8Hz

Sensitivity : 86 db

RMS power handling : 200 watts/ 400 peak

 

KAR 265

Component Set with silk tweeter

Audiophile crossover components

Injected molded poly cone

Low distortion linear suspension

High temp voice coil

Silk dome tweeter

Flush or surface mount tweeter

Rubber surround

PTC power protection

Diameter: 6.5 In

Efficiency: 87 dB/W/m

Frequency Response: 60-20k Hz

Impedance: 4 ohms

Power Handling: 100 watts (peak)

 

KAR 400.2

Power output RMS@4ohms: 2x100watts

Power output RMS@2ohms: 2x200watts

Power output RMS@1ohms: 2x400watts

 

 

KAR 1000.2T

Power output RMS@4ohms: 2x240watts

Power output RMS@2ohms: 2x450watts

Power output RMS@4ohms Bridged: 1x900watts

 

Now just got to get myself well enough to start work on the custom doorbuilds, boot build and sub enclosures to put them in! :rolleyes: ;) :D

 

Leigh.

Fookin lush mate....

gonna sound sweeeeeeeeeeeeeeeeeeeet :cool:

BTW..Hows ur dash goin?

Wow, looks awesome.

BTW..Hows ur dash goin?

My run of bad luck health wise has temporarily put the kybosh on it matey! :rolleyes: It keeps staring accusingly at me each time I hobble into the garage! Lol! :D ;) Still needs a lot of work but I reckon once I'm more mobile it shouldn't take tooooooo long to achieve a shape and finish good enough to be trimmed in leather....I hope! ;)

that's what i call a nice get well present! the pain and joy and excitement of fitting all that :dance: nice one Leigh! hope you've got some Enigma for a sound test lol!

good luck with it all mate that setup looks sweet

that reminds me, i need to bid on a Alpine v12 on ebay lol

blimey leigh got enough goodies to power brum bud

 

hope your hip gets better soon mate :)

Cheers guys! :D Just got to make up my mind whether to mount them normally or "arse out", as the rear is as good looking as the cone!

 

 

hope you've got some Enigma for a sound test lol!

Nah...Nine Inch Nails more like! ;) :D

Nah...Nine Inch Nails more like! ;) :D

Nice choice :D.

And 'arse out' I reckon - they look sweeeeeeeeeeeeet.