I Would Be Grateful To You For Any Advice.the Middle Section Of My Exhaust Pipe Has Rusted Through. The Back Section Is Fujitsubo And It Looks Like It Is Stainless. I Would Like To Replace The Centre Section With Stainless. Next Year I Hope To Increase The Bhp To Around 400-450. I Am Planning Ahead. I Dont Know The Diameter Of The Pipe But I Could Find Out.are All The Exhaust Pipes On The Market Today For The 300zx The Same Size Shape Or Length Or Would I Have To Buy A Full System Of One Particular Make .i Dont Know If The Front Section Is Stainless.is It Just Pipe Diameter That Matters When You Increase The Bhp.thanks A Lot Lads

If you need cat back then id say go for mongoose. If its the cat pipes go for a ss decat.

call allunox mate and get leon to knock u up a cat back system !! U will be amazed !!

Tell Me More About It Karlosq. I Am Interested

Custom exhausts are the dogs *****cks IMO, i changed my standard system to a single exit system with two 3 inch sections merging to 4 inch to the single silencer with a 5 inch tail. Sounds awsome when kicked but with normal driving is loud but not that loud. My car runs standard apart from the exhaust.

 

Cheers just my 2p's worth......John Crisp :duffer:

If you need cat back then id say go for mongoose. If its the cat pipes go for a ss decat.

 

Marcus when are you letting me spray that bumper!

On the original thread predator motorsport are pretty good.

 

Personally I would just get some lengths and bends of stainless with clamps and weld up some straight through pipes. My zorst on my 300 had no baffles, straight through pipes from front to back, did have to rear cans but I took all the baffles out of them.

 

Most exhaust places will weld you up a couple of pipes for say 90 a side? I know bells in swindon used to weld me up stainless replacement pipes to take out cats and centre boxes etc for about 60-90 quid.